Standard Spring Probe (Electro-mechanical) Connection Hardware & Accessories Mounting holes that match bell

Mounting holes that match bell box spacing for most mechanical run buttons

and 15 foot lengths (selectable above)

This long range 8 mm diameter shielded proximity sensor is Normally Open

*Input for scrap count (optional)

This is a chassis mount version of the connector used on the QDP kit board

Standard Spring Probe (Electro-mechanical) Connection Hardware & Accessories Mounting holes that match bellThe Standard Spring Probe is one of the oldest and most versatile sensors used for die protection. Its operation is simple: The spring is connected to a terminal that is wired to a die protection input. The whole assembly is contained in an insulated plastic block. When a piece part, the coil stock, or tooling contacts the spring, it provides an electrical path to earth ground, which is detected by the die protection control. The Standard Spring Probe